Forum Replies Created
I am CP Chen from PQSense Technology Ltd. we have sold some 50 systems to Schneider Electric China for their 10kV GIS switchgear application, in such case, temperature sensors is only applyed in incoming&outgoing cable joint location, no sensor is mount inside the GIS chamber.
You can visit our web site for more information, http://www.pqsense.com.tw
Hi Nakara, sensor is explosion proof, but reader is not. Don’t think you can use it in area require explosion proof.0April 11, 2020 at 3:50 am in reply to: Is it possible to interface passive sensors and a PLC? #2135
Yes, we hav ready made reader with built-in modbus protocol, it can inteface to any PLC , please contact me at email@example.com
Best Regards,0April 11, 2020 at 3:47 am in reply to: What Can Our Sensors Sense and Where Do Our Sensors Go? #2134
RFM3200 is suitable for non metal enviorment, you may need other n metal type sensor to do the work, we have use RFID sensor in many metal enviorment, please feel free to contact me, firstname.lastname@example.org, for further discussion on your application.
Best Regards,0April 11, 2020 at 3:41 am in reply to: Deploying RFMicron’s Temperature Monitoring System in Switchgear Equipment #2133
Hi Muller and Owen,
We have done many test on sensor temperature test, including measuring up to 125C and few hours 200 C test. if you are still interest in the topics, please feel free to contact me at email@example.com
Hi, RFID sensor with 110 C is available, 170C for fe hours is possible, but not continuous.
if you stll have problem reading the sensor, please let me know, we have experience using the sensor, maybe I can help you out.
I don’t think you can read RFM3260 from outside of autoclave, the steel will block the antenna from sensor inside the autoclave.
Hi David, I am a S3 user, below is from my experience, hopefully can be useful to you.
The S3 is a two point calibration sensor, calibration data is storeed inside S3. what A026 means is they calibrate only 1 point in factory, the 2nd calibration data is using a default value, no further calibration in factory.