Read distance between sensor and reader

Forums Forums General Discussions Read distance between sensor and reader

This topic contains 0 replies, has 1 voice, and was last updated by  RFMicron 2 years ago.

Viewing 1 post (of 1 total)
  • Author
  • #135

    RFMicron Ambassador
    • ★★★★

    A reader such as the handheld NordicID MORPHIC has a somewhat lower output power rating and the specified nominal reading range is approximately 2.5 meters or about 8 feet. This type of reader is only intended for reading RFMicron’s sensors at fairly short ranges. With the NordicID MERLIN UH reader, sensors can be read at approximately 12 meters under ideal conditions when there is an unobstructed line-of-sight view between the reader and sensor. However, read distance may be several feet less in real-world measurement conditions where obstructions and reflections can affect the RF propagation pattern.


Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

Axzon (formerly RFMicron)

3700 N. Capital of Texas Hwy
Suite 570
Austin, TX 78746
Tel: (512) 535-4647

Privacy Preference Center

Strictly Necessary

Cookies that are necessary for the site to function properly. Without these cookies, users would be unable to log into the community to add posts and antispam monitoring would be disabled.

PHPSESSID, wordpress_, JCS_INENREF, JCS_INENTIM, gdrp, _dc_gtm
_ga, _gid

Close your account?

Your account will be closed and all data will be permanently deleted and cannot be recovered. Are you sure?