Obtaining an “On-Chip RSSI target not met” message

Forums Forums General Discussions Obtaining an “On-Chip RSSI target not met” message

This topic contains 0 replies, has 1 voice, and was last updated by  RFMicron 2 years ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #138

    RFMicron
    RFMicron Ambassador
    • ★★★★

    When reading an RFMicron sensor, an “On-Chip RSSI target not met” message may be displayed on the screen, even though the reader is in close proximity to the sensor (ie: within a couple of feet). This message is a warning; it doesn’t necessarily mean the sensor reading is invalid. In case 1, too much received power at the tag’s chip (On-Chip RSSI too high) can distort sensor readings, so software suggests that you be cautious about the reported result. However, too little power (On-Chip RSSI too low) means that the sensor might be difficult to read, but that the sensor values will still be valid if the read process completes. If you are more than 2 or 3 feet away from the tag and you get an “RSSI too low” message, it’s likely related to too little RF power on the sensor. You can check the numerical value of the On-Chip RSSI by enabling the Dashboard feature in the software.

     

    0
Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

Axzon (formerly RFMicron)

3700 N. Capital of Texas Hwy
Suite 570
Austin, TX 78746
Tel: (512) 535-4647
Axzon.com

Privacy Preference Center

Strictly Necessary

Cookies that are necessary for the site to function properly. Without these cookies, users would be unable to log into the community to add posts and antispam monitoring would be disabled.

PHPSESSID, wordpress_, JCS_INENREF, JCS_INENTIM, gdrp, _dc_gtm
_ga, _gid

Close your account?

Your account will be closed and all data will be permanently deleted and cannot be recovered. Are you sure?